KitchenAid-Black-Stainless-Catalog

Dimensions 40 Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice. Cooking SINGLE WALL OVENS PRODUCT DIMENSIONS CUTOUT DIMENSIONS MODEL NO. 30-INCH KOSE500EBS PRODUCT DIMENSIONS Recessed Width (A) 28 1 / 2 max. Overall Height (B) 28 3 / 4 max. Overall Width (C) 30 Recessed Depth (D) 23 1 / 4 max. Recessed Height (E) 26 3 / 4 OVEN CAVITY DIMENSIONS Width 25 Height 18 Depth 19 CUTOUT DIMENSIONS Width (F) 28 1 / 2 Height (G)  28* Depth (H) 24 *Recommended cutout height. Will fit cutout height from 26 15 / 16 " to 29 7 / 16 ." 1 1 / 2 " min. bottom of cutout to top of cabinet door 32" bottom of cutout to floor 1" top of cutout to bottom of upper cabinet door F E Min. Cabinet Width 30" F G 36," 30," 27," 24" Undercounter 5 1 / 4 " bottom of cutout to floor w/o cooktop on top – 1 1 / 2 " min. top of cutout to underside of countertop 1 1 / 2 " min. bottom of cutout to top of cabinet door Min. Cabinet Width (24," 27," 30") cabinet oven front Min ( Cabinet Side View bottom of cutout to floor w/cooktop on top E F Single Oven Undercounter F Si 3 5 / 8 "-4 5 / 8 " H D F G 36," 30," 27," 24" Important Installation Information Regarding Flush Install Flush Install requires a special kit. Regarding the Steam Function The steam function on this oven is configured for direct plumbing to a nearby water supply. Included with the product are the water filter housing, one water filter, a small section of copper tubing at the back of the oven, and a water supply union to attach the copper tubing to the water supply line. Water supply lines are not included. The water filtration system should be installed upright and adjacent to the oven near the cold water supply pipe under the kitchen sink. See Installation Instructions for complete details. Min. Cabinet (24," 27," cabinet oven front Cabinet Side View E F Single Underc H D Cabinet Side View LOCATION REQUIREMENTS Electrical supply junction box should be located 3" maximum below the support surface when the oven is installed in a wall cabinet. A 1" minimum diameter hole should have been drilled in the right rear or left rear corner of the support surface to pass the appliance cable through to the junction box. NOTE: For undercounter installation, it is recommended that the junction box be located in the adjacent right or left cabinet. If you are installing the junction box on rear wall behind oven, the junction box must be recessed and located in the upper or lower right or left corner of the cabinet; otherwise, the oven will not fit into the cabinet opening. E A B C D DIMENSIONS – shown in inches